phil
New Member
Posts: 3
|
Post by phil on Jul 10, 2017 11:07:05 GMT -7
Okay, I have a feeling this should be an easy fix, but when I "move antennasto center" our tilt servo is pointing in a slightly downward position. I believe this is causing our tracking to be off just a bit as the antenna tracks the payload and is causing a slight loss in signal power between our Arduino modems. When you click on "move antennas to center" how does it determine what position to move it to, and can I adjust that a bit? Thanks!
Phil
|
|
|
Post by Austin MnSGC on Jul 10, 2017 12:32:08 GMT -7
When you hit the Move Antennas to Center button, it moves both servos to their zero position. You should notice that move antenna to center moves them to the same place they go to when you first power them.
It is possible for the zero of the servos to change, and this usually happens if they are rotated too far while not powered. What you can do is set them to face their zero position, then use a screwdriver to turn screw in the center of the servo gear until they are facing the direction that you want for the zero position.
|
|
phil
New Member
Posts: 3
|
Post by phil on Jul 10, 2017 12:34:29 GMT -7
fantastic...thanks so much!
|
|