|
Post by nzarilla on Oct 3, 2016 12:56:07 GMT -7
The coaxial connector shown in this image was damaged, and requires replacement. As I can't seem to find one online, would it be possible to get a part number or a name for this type of jack? www.imgur.com/d0H7ZEy.jpg
|
|
|
Post by Iadevaia on Oct 3, 2016 13:13:10 GMT -7
Original post removed by moderator: wrong part suggested
All SMA connectors on the RFD radios are reverse polarity. Part descriptions are designated by RP-SMA
|
|
|
Post by nzarilla on Oct 4, 2016 6:27:23 GMT -7
Thank you.
|
|
|
Post by David MSGC on Oct 5, 2016 10:05:33 GMT -7
I am not sure if the suggested part is correct it appears to have an SMA connector and it should be RP-SMA. I would double check that connector and make sure it is a RP-SMA and not just a regular SMA the pin will be opposing polarity and this is what caused all the confusion in the workshop, some cables were shipped erroneously as SMA when they should be RP-SMA. It will damage the radio if it is the wrong one since the antenna will essentially not be connected and create the same issue as running a transmitter without the antenna attached.
|
|