nimdok
Novice Ballooner
Posts: 8
|
Post by nimdok on Jun 16, 2017 14:40:06 GMT -7
If I want to have the antenna point at the payload I need to shutdown the GUI and do all the start up steps again to have the antenna point at the payload position. I can't get the auto tracking or point to last position to work.
|
|
|
Post by Austin MnSGC on Jun 17, 2017 15:35:41 GMT -7
The location that the ground station believes the balloon is at is in the upper left table. It will also tell you the tracking method this information was acquired from. If the information in that table is not updating, then you are not receiving new location information.
If it is updating, but your tracker is not aiming at it, you'll want to check your servos.
|
|