Issues 3D printing replacement pieces

[rmungin]

Hello!

I need to print a new IMU mount - but the .stl files provided are not the right size. I have imported them into Repetier Host and Slic3r and the parts are very small. I tried scaling by 2000% and it is still too small. Were these parts designed in solidworks? If so could I get the original files? Or is there a specific scale factor I need to consider?

Thanks!

[carter12594]

IMUmountLARGE.sldprt (70.5 KB)IMUmountSMALL.sldprt (62.5 KB)

Here are two models. We have been using the smaller one of the two since the IMU is in line with the rail.